Release TerrariumPI v 4.3.0

Release 4.3.0

This release has a lot of small fixes. Also this release will support more hardware. Get the new version here.

Here are some highlights of this release.

IO Expander

There is now support for two IO expander boards. This way, you could add more buttons and GPIO relays though I2C bus. This expander boards can only toggle ports on or off. It is not possible to use it for sensors.

Area updates

There were some bugs in the area setting of an enclosure. Those are fixed and there is a new feature. You can now ignore alarm values per area if needed. So for the low alarm tab, you can now ignore the low alarm, and only use the high alarm value for toggling relays.

Also there is a better check for depending areas. So when the area you depend on turns in an alarm state, it will also shutdown the area that depends on it.

Hardware

We now support SHT4X and BME680 sensors and RTSP based webcams.

Also we support hardware PWM again like the old legacy way in TP3.

So, go the installation page in order to install Terrarium PI version.