Home SEN0161 PH Probe sensor (analog)
Post
Cancel

SEN0161 PH Probe sensor (analog)

Information

Need to measure water quality and other parameters but haven’t got any low cost pH meter? Find it difficult to use with Arduino? Here comes an analog pH meter, specially designed for Arduino controllers and has built-in simple, convenient and practical connection and features. It has an LED which works as the Power Indicator, a BNC connector and PH2.0 sensor interface. To use it, just connect the pH sensor with BNC connector, and plug the PH2.0 interface into the analog input port of any Arduino controller. If pre-programmed, you will get the pH value easily. Comes in compact plastic box with foams for better mobile storage.

Attention: In order to ensure the accuracy of the pH probe, you need to use the standard solution to calibrate it regularly.Generally, the period is about half a year. If you measure the dirty aqueous solution, you need to increase the frequency of calibration.

More information …

Setup

In order to use the SEN0161 PH Probe sensor (analog) use the following settings:

Mandatory

Hardware
SEN0161 PH Probe sensor (analog)

Types : ph

Address
Analog and enter port number
Ex: 1

Other settings can be found at the sensor setup information

This post is licensed under CC BY 4.0 by the author.