Qwiic Relay
Information
Qwiic Relays are available in different configurations:
- Single relay
- Quad relay
- Dual Solid State relay
- Quad Solid State relay
These relays are addressable through I2C and can be controlled by any micro-controller with I2C support. This allows to control various appliances.
Power issues
There are some reports that the Qwiic relays only works with a 5volt power despite it should be able to run on 7-12 volt. So if the device is not working, try switching to 5 volts.
Setup
In order to use the Qwiic Relay use the following settings:
Mandatory
- Hardware
- Qwiic Relay
- Address
- <I2C Address>,[I2C Bus] where the I2C bus is optional
Ex:1,0x3f
Other settings can be found at the relay setup information
This post is licensed under CC BY 4.0 by the author.