Sonoff D1 Dimmer (Tasmota/DIY)
Information
This is a dimmer device which can be controlled through Wifi. It can dim normal as led lights at 100-240 Volt.
The device needs either to be flashed with Tasmota, or you need it yo put in DIY mode.
When you add the Sonoff D1 Dimmer, TerrariumPI will automatically detect which mode it should run.
Tasmota
Total local control with quick setup and updates. Control using MQTT, Web UI, HTTP or serial. Automate using timers, rules or scripts. Integration with home automation solutions. Incredibly expandable and flexible.
It needs to be flashed with Tasmota firmware!
DIY Mode
With the D1 Dimmer it is also possible to use the DIY mode so you do not need to flash your device. This can be done with the original software on the hardware device. But you need a 433Mhz remote controller to put the device in AP mode to setup your wifi.
Follow these steps to setup your Sonoff D1 Dimmer in DIY mode
Setup
In order to use the Sonoff D1 Dimmer (Tasmota/DIY) use the following settings:
Mandatory
- Hardware
- Sonoff D1 Dimmer (Tasmota/DIY)
- Address
- Enter the hostname or IP address including port number.
Other settings can be found at the relay setup information